Cause of Invalid Partition Table
Generally, we divide the hard dives
into equal partitions. This helps to use the entire
space without loosing on any data. We can change the
ratio of each partition as per our requirement. The
information regarding these partitions is stored in
a partition table. This table can be found in the primary
location of the hard drive and it cannot be accessed
at all. If the any of the files are not working properly
or if the system is not able to recognize the memory
portions, invalid partition table message
will come up.
Information regarding the memory space, file system
type, boot sector is kept on the hard drive. That is
why it is prescribed to divide the partition into minimum
four parts, so that system could avoid invalid
partition table errors from the very beginning.
It is always good if we make equal partition. It becomes
easier to access any data from any where. But if the
the system is not able to access these the portion of
the hard dive then may loss all data saved on the hard
drive and on the top of it the system will not recognize
the hard drive. We may also see that, system is not
able to read the partitions or it may miss the operating
system files. Invalid partition table
error may also appear while loading the operating system.
However, if the invalid partition table
happens then all the proportion of the hard drive would
be removed and the data cannot be accessed. In this
case we can either remove the particular program caused
the error or need to use the partition recovery software.
While installation it is better, if save the file on
other drives. These are causes behind the invalid
partition table issue.