the Error 25
Error 25 is commonly
known as fault system 25: Thermal blend. In order to
verify with the aim of the issue is genuine, we may
use a Volt/Ohm Meter. It could be analog or digital.
These thermal fuses are same as ordinary fuses. These
thermal fuses are affected by excess load, power surge
and with the passing time it looses its capacity. Error
25 happens if the thread breaks along with
the insufficiency of power. However we can check whether
there is any power or not with the help of the meter.
In order to eliminate the error 25,
we need to repair the thermal fuse. We need to replace
the fuse for that. So for this we need to have a Phillips
Head Screwdriver, a Small Slotted Screwdriver; a three
inch twisted pair and two seven by sixteen unlocked
twist. We need to check the statim inside the cover.
There we would find a vapor producer, a computer panel
and a hydraulic propel. Before we substitute the fault
system, we need to check the boiler with the computer
panel. The fault system is positioned below the vapor
producer. The vapor producer has the white insulation.
Now we could do with some quantity of the wires attached
with the boiler. We would require detaching it and need
to take out the closed bracket.
It is not the end of the error 25.
Now we need to unplug the wire from the outdated fuse
and need to replace it with the new fuse. However, we
need to take care of certain factors and we need to
cover the fuse properly. In this way we would save lot
of money and also getting to know the functionality
of the statim. This is how we fix the error